@article{melchert_anisotropic_nodate,

title = {Anisotropic Thermally Conductive Composites Enabled by Acoustophoresis and Stereolithography},

author = {Drew S. Melchert and Amir Tahmasebipour and Xin Liu and Julie Mancini and Bryan Moran and Brian Giera and Ishan D. Joshipura and Maxim Shusteff and Carl D. Meinhart and Corie L. Cobb and Christopher Spadaccini and Daniel S. Gianola and Matthew R. Begley},

url = {https://onlinelibrary.wiley.com/doi/abs/10.1002/adfm.202201687},

doi = {10.1002/adfm.202201687},

issn = {1616-3028},

year  = {2022},

date = {2022-05-17},

urldate = {2022-05-17},

journal = {Advanced Functional Materials},

pages = {2201687},

abstract = {Opportunities to improve thermal management in electronic devices are currently hindered by processing constraints that limit thermal conductivity in polymer-matrix composites. Active patterning of filler particles is a promising route to improve conductivity while retaining processability by improving particle contact density and directing heat along optimized pathways. This study employs acoustic patterning to align and compact filler particles into stripes during stereolithographic 3D printing. This approach produces polymer-based composite materials with highly efficient embedded heat transport pathways which reach 95 vol% particle utilization (relative to the parallel conduction upper limit). These composites exhibit anisotropic thermal conductivity up to 300% higher than unpatterned composites, with in-plane anisotropy ratios of up to 350%. Combining this high conductivity with 3D printing enables materials with engineered heat networks that optimize transport from hot spots to heatsinks while maintaining low viscosity for fast particle patterning and for infiltration around electronic components. Finally, numerical simulations of acoustic assembly of particles with varied geometry, when compared to experimentally characterized particle packing, illuminate pathways for further improving conductivity by optimizing particle geometry for alignment and stacking of particles with maximum contact surface area.},

keywords = {3D printing, acoustophoresis, composites, stereolithography},

pubstate = {published},

tppubtype = {article}

}